HASSentrik Eccentric sleeve
Ability to use HASSentrik with a standard veldon holder gives an economic advantage.
WHAT ECCENTRIC SLEEVE IS USED FOR?
This sleeve is used for adjusting diameter value in decimals between Ø+0.5-Ø-0.25mm in drilling with U-drill.
Example: Holes of Ø23.75 mm to Ø24.5 can be bored with Ø24 Standard U-drill by using eccentric sleeve.
- U DRILL
- ECCENTRIC SLEEVE
- WELDON TOOL HOLDER
- STEP SETSCREW
POINT TO CONSIDER DURING MOUNTING
While tightening setscrew bolt (4) provided with HASSentrik, The outer insert of U-drill should remain on the left hand side of setscrewbolt.
| Code No | Code | D | d | L |
|---|---|---|---|---|
| EKS 220 | EKS 25-20 | 25 | 20 | 40 |
| EKS 325 | EKS 32-25 | 32 | 25 | 40 |
| EKS 432 | EKS 40-32 | 40 | 32 | 40 |